Replacement Coil / Atomizer Head for Kanger CLTANK
Replacement atomizer head for:
- Kanger CLTANK 2.0
- Kanger CLTANK 4.0
- Kanger EVOD PRO
- Kanger CUPTI
CLOCC (Organic Cotton Coils):
Stainless Steel may be used in Power (Wattage) Mode or Stainless Steel Temperature Control Mode:
- SS316L - 0.5ohm (Recommended Wattage Range: (15 - 60W)
Nickel (Ni200) must be used in Nickel Temperature Control Mode:
- Ni200 - 0.15 ohm (Please note, the Ni200 Atomizer Head is not compatible with the EVOD PRO)
Tip for new users: We strongly suggest 6mg eLiquid or lower with this atomizer. Sub-ohm atomizers produce higher throat hit than low and standard resistance atomizers. Using this atomizer with a nicotine level above 6mg will usually taste burnt or harsh.
Risk of battery Explosion! Nickel (Ni200) are designed for use only with devices equipped with circuit boards capable of controlling coil temperature, such as DNA 40 Mods. Do not use this product with any other devices.
Warning: This is a sub-ohm resistance atomizer. It will only work on a mechanical mod or a mod capable of firing an atomizer of 0.5ohm or lower. You must be sure that your mod AND batteries can handle SUB OHM coils. If you're using a regulated mod, make sure it can handle the amps. For mechanical mod users, please use 20 amp batteries or higher. Use the OHMS LAW CALCULATOR, CHECK YOUR AMPS, and be safe! Any questions please contact us by email.
Please Note: This product is not covered by warranty and cannot be exchanged.